 |
 |
 |
|
|
|
|
If you have a question or comment, you can E-Mail us, or call us during business hours-anytime. |
|
 |
24 hour Hotline: (in China) |
| |
(86)13915497733
OR
(86)13817098656 |
|
|
E-mail: |
|
|
|
 |
 |
 |
|
|
|
|
|
Services |
++ |
|
|
++ |
Resolve Normal Problems |
|
++ |
|
|
|
|
|
|
|
|
|
|
|
|
|
Services/Resolve Normal Problems |
|
| + + |
Bad Appearance ? |
| |
Possible Problem: The tension adjustment is not good.
** Resolve Method: 1. Record by the operating experience, to convenient for next use.
2. Install automatic tension controller.
Possible Problem: Material lamination is not good.
** Resolve Method: 1. Reduce the speed.
2. Use the aluminum press roller.
Possible Problem: Material problem.
** Resolve Method: If PE, each rolls need aluminum press roller. |
| + + |
Waste Can't be Removed ? |
| |
Possible Problem: Bad adjustment of stimy plate of waste pipe.
** Resolve Method: Press down “scratching flow plate”, and add “refluence effect”.
Possible Problem: Wind quantity of blower
** Resolve Method: wind quantity should be direct proportional to the quantity of waste.
Possible Problem: Too big waste
** Resolve Method: Waste rewinding roller.
Possible Problem: Waste remove process is not good.
** Resolve Method: Use the guide piece on the pipe to adjust the pipe angle. |
| + + |
|
| |
Possible Problem: Material problem.
** Resolve Method: Change the circular blade or razor blade such as material that is
more brittleness, thicker, softer.
Possible Problem: The edge of knife is abrasion.
** Resolve Method: Change a new one.
Possible Problem: weather affected.
** Resolve Method: If CPP, pre-heating to reduce the material brittleness and then slit. |
| + + |
The Length of product is inaccurate ? |
| |
Possible Problem: Material problem (skid with rubber roller).
** Resolve Method: The material is too smooth, so the length counter must press on
the material.
Possible Problem: The checking Unit is out work.
** Resolve Method: Use the hand to see whether there has any sign into the length
counter or not.
Possible Problem: the length counter problem.
** Resolve Method: If there is no reaction on the when the checking unit has inputted,
change a new one. |
| |
|
|
|
|
|
|
|
